If you want your bore system to actually run efficiently, you need to understand one thing most Australians skip: the bore pump performance curve. This curve determines whether your pump will deliver consistent flow, stable bore water pressure, and long-term...
If you’re relying on bore water in Australia, there’s a good chance your system is only performing at a fraction of what it could. Most people obsess over the pump model and ignore the fundamentals: bore water yield and bore...
If you’re using a bore to supply water on your Australian property, understanding how pump head and pressure affect your system is absolutely critical. Mis-calculating either means you’ll end up with poor flow, wasted electricity, or pump failure. In this...
Getting bore water right in Australia isn’t just about drilling a hole and hoping for the best. When your bore runs deep, produces variable yield, or carries sediment, a standard centrifugal submersible pump often won’t cut it. This is where...
If you’re a property owner in Australia looking to tap into bore water, the question “what size bore pump do I need” isn’t just academic it’s critical. Get the sizing and pump type wrong and you’ll either under-perform or waste...
Rural Australians rely on bore water more than almost any other group in the country. When your entire property depends on a stable water supply, choosing the right bore pump is not optional it’s the backbone of daily life. But...
Across Australia, the most overlooked factor in bore pump performance is pump head. People obsess over flow rate, horsepower, pump type, or bore depth, but the real bottleneck is often head pressure. When you misunderstand head, everything else falls apart...
Australia’s harsh climate and variable groundwater conditions push bore pumps harder than most people realize. The result? Recurring failures that usually trace back to one root cause: the pump was the wrong size, installed incorrectly, or never matched to the...
Introduction If you’re managing a bore on your Aussie property, one of the biggest mistakes you can make is getting the pump sizing wrong. Whether you choose a submersible or a surface bore pump, the key is sizing it properly...
